Product Details
Blue Smart 120V 1-Bank Battery Charger by Victron Energy®. The Blue Smart IP65 Charger is the new professional battery charger with built-in Bluetooth. The Blue Smart IP65 Charger can be used on devices in your workshop and on motor vehicles, such as (classic) cars; motorbikes; boats and camper-vans.
Specifications
| Input voltage range: 180 – 265 VAC |
| Efficiency: 93% |
| No load power consumption: 0.5 W |
| Frequency: 45 – 65 Hz |
| Number of outputs: 1 |
| Charge voltage 'absorption': Normal 14,4V, High 14,7V, Li-ion 14,2V |
| Charge voltage 'float': Normal 13,8V, High 13,8V, Li-ion 13,5V |
| Charge voltage 'storage': Normal 13,2V, High 13,2V, Li-ion: 13,5V |
| Charge algorithm: 6-stage adaptive |
| Can be used as power supply: Yes |
| Protection: Battery reverse polarity (fuse), Output short circuit, Over temperature |
| Operating temp. range: -20 to +50°C |
| Humidity (non-condensing): Max 98% |
| Material & Colour: Aluminium (blue RAL 5012) |
| Battery connection: Screw terminals 13 mm² / AWG6 |
| AC connection: Cable of 1,5 meter with plug |
| Protection category: IP22 |
| Weight: 1,3 kg |
| Dimensions (h x w x d): 235 x 108 x 65 mm |
| Safety Standards: EN 60335-1, EN 60335-2-29 |
| Emission Standards: EN 55014-1, EN 61000-6-3, EN 61000-3-2 |
| Immunity Standards: EN 55014-2, EN 61000-6-1, EN 61000-6-2, EN 61000-3-3 |
| Automotive Standards: E4-10R |
Features
- Water, dust and chemical resistant
- Seven step smart charge algorithm
- Recovery of fully discharged‘dead’batteries
- Automatic power supply function
- Severe cold performance: down to -30°C
- Several other battery life enhancing features
- Low power mode to charge smaller batteries
- Li-ion battery mode
- Setup and configure, readout of voltage and current by Bluetooth Smart
High efficiency
With up to 94% efficiency, these chargers generate up to four times less heat when compared to the industry standard. And once the battery is fully charged, power consumption reduces to 0,5 Watt, some five to ten times better than the industry standard.
Adaptive 6-stage charge algorithm: test - bulk – absorption - recondition – float – storage
The Blue Smart Charger features a microprocessor controlled ‘adaptive’ battery management. The adaptive feature will automatically optimize the charging process relative to the way the battery is being used.
Storage Mode: less maintenance and aging when the battery is not in use
The storage mode kicks in whenever the battery has not been subjected to discharge during 24 hours. In the storage mode float voltage is reduced to 2,2V/cell (13,2V for a 12V battery) to minimize gassing and corrosion of the positive plates. Once a week the voltage is raised back to the absorption level to ‘equalize’ the battery. This feature prevents stratification of the electrolyte and sulfation, a major cause of early battery failure.
Also charges Li-ion (LiFePO?) batteries
LiFePO? batteries are charged with a simple bulk – absorption – float algorithm.
NIGHT and LOW setting
When in NIGHT or LOW mode, the output current is reduced to max. 50% of the nominal output and the charger will be totally noiseless. The NIGHT mode automatically ends after 8 hours. The LOW mode can be ended manually.
Protected against overheating
Output current will reduce as temperature increases up to 50°C, but the Blue Smart Charger will not fail.
Eleven LEDs for status indication
Charge algorithm: TEST / BULK / ABSORPTION / RECONDITION / FLOAT / STORAGE / READY.
MODE button to set: NORMAL (14,4V) / HIGH (14,7V) / RECONDITION / LI-ION.
Victron Energy® products include sinewave inverters, sinewave inverters/chargers, battery chargers, DC/DC converters, transfer switches, battery monitors and more. Victron Energy has a strong, unrivalled reputation for technical innovation, reliability, and build quality. Victron Energy products are widely considered to be the professional choice for independent electric power.